I have been patiently waiting for my HID kits to arrive, which they now have. So i decide im going to install them today....but im having some problems. Let me first start out by saying i have absolutly no knowledge of wiring or anything electrical AT ALL!
The instructions are poorly written (from china) so im having some trouble.
I have a xenon kit (4300k, H13) and also the fogs (i got 9005). I know i will loose my high beams, not worried. ok...here goes...
I have a relay that connects to the positive and negitive on my battery, which I have already connected. and 2 small single wires (assuming they are ground wires, where can i put these?) 2 more cables coming from the relay that connects to each ballast. SO, i connect the cable to the ballast, and from the ballast, another cable goes to my Xenon bulb. But the bulb has another cable coming from it that i assume connects to my factory plug? If so, it doesnt fit. So i TRIED to splice it.
On my factory plug i have a black wire, a green/black wire, and a orange/green wire. I assume i will only be using 2 of the wires to connect since i will only be using my low beams. I have tried every combination....no light! There are also 2 small ground wires coming from the bulb....where do those go? Do they have to be connected to anything for my kit to work? I NEED HELP...anyone have any knowledge of a single xenon kit...or have any WELL WRITTEN directions on how to hook this up?
ok, here is the bulb with all wiring
the relay (already hooked up)
and how i have the HID bulb plugged into my factory headlight
now when I done the fogs, no relay was used, theres a few different wiring diagrams...certain bulbs use certain ones....H13 isnt listed. Im assuming that I will use the relay, but not certain. the last picture....at the bottom by the headlight socket u see 2 wires...by themselves, like pigtails or something...are these grounds? so I splice this into my ground from my factory headlight socket? Im very lost...can someone just tell me a simple diagram of an H13 HID SINGLE xenon on which wires go where?
heres a shot of the fogs i already have hooked up
if someone could walk me through this it sure would help a lot. Thanks
h13 xenon kit (2007 f150)
Linear Mode
